Bob Smith Industries Maxi-Cure CA Extra Thick 14g BSI111

Bob Smith Industries Maxi-Cure CA Extra Thick 14g BSI111

Maxi-Cure Glue for Ceramics/Plastics/Hardwoods

De hoge viscositeit van Maxi-Cure is uiterst geschikt voor de meeste kunststoffen en het is ook nog eens geschikt voor fiberglass, metaal, hout en rubber. In samenwerking met Insta-Set kan het ook gebruikt worden voor het opvullen of aanpassen van gaten. Uitgehard kan het bijgewerkt worden met een mesje en geschuurd en gepolijst worden waardoor het met het oog niet te onderscheiden is van kunststof.

Gebruikstabel:

• Balsa Wood (**)
• Soft wood (***)
• Hard wood (***)
• Glass and metal (***)
• Fiberglass (***)
• Ceramics (***)
• Hard plastic (***)
• Rubber (***)
• Water resistant (**)
• Filling (**)

Bonds most plastics. Full strength is reached in 2 hours.

Heat and moisture will decrease the shelf life of CAs. Unopened bottles can be stored in a freezer or refrigerator, but allow them to reach room temperature before using. Keep your bottles in a cool place that won’t be exposed to direct sunlight and store away from bottles of accelerators. Due to the freshness of our CAs, their shelf life is guaranteed for 24 months.

For the initial opening of the top, loosen and retighten the top first to relieve internal pressure, then hold the bottle against a near vertical surface and cut off the top 1/32″ with a knife or razor blade without squeezing the bottle. To prevent clogging, do not let the tip of the nozzle touch a surface that has been sprayed with INSTA-SET™. Before replacing the colored cap, set the bottle down hard to knock the remaining CA back into the bottle before squeezing it in an upright position to blow air through the nozzle, then wipe the tip clean.

With all CAs, the closer the parts fit together, the stronger the bond. Always hold the bonding surfaces together as tightly as possible. Any rough spots on the mating surfaces should be smoothed out. Although CAs will hold objects together with considerable strength within seconds, the full strength of the bond is not reached for several hours. Allow for this before subjecting parts to maximum stress. Also, CAs are generally a little less brittle and have higher strength when they are allowed to cure on their own.