Traxxas BEC Complete (includes receiver box cover and seals) 2262

Traxxas BEC Complete (includes receiver box cover and seals) 2262

This BEC is to be used in combination with a Traxxas ESC with external power cable.

The BEC is connected in between the ESC and the receiver. You no longer plug the ESC into channel 2 of your receiver, but you connect the ESC into this BEC, and this BEC into the receiver. You also connect the BEC to the red wire that comes out of the ESC, so the BEC can give a stabilised 6V voltaged directly from the battery to the receiver, instead of the internal BEC of the ESC. This means it completely bypasses the internal BEC in the ESC which might not be powerfull enough to supply power to all your electronics (For example when using Traxx, light sets or multiple servo’s).

Kit contents:
• Battery eliminator circuit (BEC)
• Receiver box cover
• Bind plug
• Wire clamp
• O-ring
• Foam pads (3)
• Y-harness
• 2.5x8mmCS(2)
• Silicone grease
• Zip tie (1)

BEC Installation:

1. Remove the three 3x8mm BCS from the existing receiver box cover; remove the cover.
2. Peel the backing from the “L” shaped foam pad and secure it the smooth surface portion on the bottom of the BEC.
3. Remove the backing from the other side of the foam pad and install the BEC onto the receiver as shown. Install the new o-ring seal on the receiver box. Ensure that the o-ring is properly seated in the groove.
4. Route the BEC power wire through the new receiver box cover.
5. Loosen the screws in the battery tray. Lift the battery tray and route the BECpower wire under the battery tray and over to the electronic speed control

   (ESC) (see Wiring Diagram).

6. Remove the existing zip tie, and then use the included zip tie to secure thewires to the transmission housing. Note: Ensure that no wires are pinched

   before retightening the screws in the battery tray.

7. Loosen the screws in the ESC and route the BEC power wire behind andunder the ESC (see Wiring Diagram). Retighten the screws. Plug the red female connector from the BEC power wire into the red male connector from the ESC. Note: Use the supplied “Y” harness if another accessory is already plugged into the ESC.
8. Unplug the ESC connector from Channel 2 of the receiver; plug the connector into the BEC.
9. Plug the black connector from the BEC into Channel 2 of the receiver.
10. Install the remaining foam pads on the new receiver box cover and wire clamp.Apply a small bead of the supplied silicone grease to the foam pads.
11. Install the new receiver box cover using the 3x8mm BCS.
12. Place the BEC wire in the wire guide of the receiver box cover and installthe wire clamp using the included 2.5×8 mm CS. Install the bind plug in the receiver box cover.

Downloads
Traxxas BEC Complete 2262 Manual PDF